Concrobium Mold Control - Fogable / Sprayable / Wipeable Mold Cleaner & Preventer

(1 review) Write a Review
In Stock - Ships Same Day if Ordered by 3pm CST!
Bulk Pricing:
Buy in bulk and save


Mold Control by Concrobium Pro


  • Single solution remediates and prevents mold
  • No bleach, ammonia or VOCs
  • EPA-registered for hard surface and fabric applications
  • Requires zero isolation time and is completely odorless
  • Can be fogged to treat large and inaccessible spaces
  • Ready to use solution – no mixing required 
  • Foggable / Sprayable / Wipable
  • Ready to use solution – no mixing required 

Recommended Uses: 

  • Concrobium Mold Control can be used in homes, businesses, institutions, cottages, RVs, boats – anywhere that mold takes hold. 
  • Disaster restoration - mold remediation and prevention following flooding and leaks
  • Construction and renovation – pre-treatment of building materials (e.g. drywall, lumber) for mold prevention; elimination of mold found during renovations
  • Specialty mold clean-up and prevention – Cars, RVs, boats, sporting equipment 
  • Safe for use on virtually any surface (finished and unfinished): drywall, lumber, plaster, concrete, siding, shingles, composite decking, metal, marble, tile, grout, fabric, upholstery, furniture, and clothing.
  • Safe for use on hard surfaces and fabrics

Application Guidelines

For best results, apply a thin, even  coating of Concrobium Mold Control to the surface,  and allow to dry thoroughly. Once dry, use product to clean any residual staining. If staining persists, use Concrobium Mold Stain Remover to completely remove all mold staining. Leave a thin, even coating of product on the surface to provide protection against mold.

Application techniques – Roller, brush, rag, garden sprayer. Can also be applied with a cold fogging
machine to treat large or inaccessible areas.

Coverage – Coverage varies according to surface and application method.

Fogging: approximately 1,400 sq ft. per gallon (the equivalent of a 20’ x 20’ room with 8 foot ceilings, all surfaces).

Spray (manual or compression sprayer): Approx. 500 sq. ft. per gallon depending on sprayer type and surface
absorbency. Expect reduced coverage on absorbent surfaces such as fabrics, carpet, lumber and unpainted drywall.

Special application instructions – Do not dilute. Do not rinse. Do not use bleach-based products in
combination as this may reduce product efficacy.

Handling – No special controls, ventilation, or personal protective equipment is required while handling the product. To avoid applicator exposure to mold or mold spores during use, consult product label

Storage – Store containers between 39°F and 100°F. If product freezes, thaw and mix thoroughly.


  • Appearance: Clear liquid
  • Price Unit: 1 gallon
  • Standard Package: 1Gallon Jug
  • Boiling Range: 212*F / 100*C
  • Weight: 8.5lbs
  • Evaporation Rate: Slower than Ether
  • Vapor Density: Heavier than Air
  • pH: 11.1 - 11.5 
Important Documents:

Warranty Information

100% Manufacturer Satisfaction Guarantee.

1 Review Hide Reviews Show Reviews

  • 5
    easy to use

    Posted by Unknown on 21st Aug 2014

    I used a garden sprayer and spread a fine mist over the basement walls. After letting it dry using a fan I was able to paint the same day. There was no smell or mess. It was so easy.